The Jeep Grand Cherokee is a popular mid-size SUV. It is known for its off-road capabilities, as well as its luxurious interior. This vehicle is a favorite of many drivers, and it’s important to keep the Jeep Grand Cherokee in top condition by performing regular service.
To reset the Jeep Grand Cherokee’s four-wheel drive system, you need to turn on the ignition, however, do not start the engine. After that, press the acceleration three times and turn off the ignition. Start the engine after 10 seconds.
In this article, I will show you how to reset the 4wd system on your Jeep Grand Cherokee.
How To Reset the 4WD Service Required Message
Resetting the Jeep Grand Cherokee’s four-wheel drive system is a simple process that can be done at home. Here is a step-by-step guide on how to do it:
- Step One: Turn on the ignition. However, you should not start the car. Just let it sit there and idle.
- Step Two: Press the accelerator three times.
- Step Three: Turn off the ignition. Step Four: After ten seconds have passed, start the engine.
How To Reset the 4WD Error Message
First, find the fuse box. The fuse box is under the Jeep’s hood and has a label that says “fuses.” Once you find the fuse box, locate the fuse for the four-wheel drive system.
This fuse is usually labeled with the letters “FWD.” Next, you will need to disconnect the cable of the negative battery. You can use a wrench to loosen the nut on the cable clamp.
Once the negative battery cable is disconnected, you can remove the fuse from the fuse box. Now, reconnect the negative battery cable. Be sure to tighten the nut on the cable clamp securely. If you do not, your Jeep may have electrical problems. Finally, start the engine and see if the error message has reset.
To do this, simply put the Jeep in a four-wheel drive and drive around for a bit. If everything is working properly, you will hear the four-wheel drive engage and disengage as you turn. If it has not, you may need to take your Jeep to a mechanic for further diagnosis.
Why Reset the Jeep Grand Cherokee 4WD System?
There are a few reasons why you might need to reset the four-wheel drive system on your Jeep Grand Cherokee.
Trouble Engaging and Disengaging the 4WD
A vacuum switch controls the Jeep Grand Cherokee’s four-wheel drive system. This switch can become damaged or dislodged, which can cause problems with engaging and disengaging the four-wheel drive. Resetting the system may fix the problem if you are having trouble engaging or disengaging the four-wheel drive.
The “Service Four-Wheel Drive” Message is On
If the “Service Four-Wheel Drive” message is on, it means that there is a problem with the Jeep’s four-wheel drive system. Resetting the system may clear the message and fix the problem.
The Jeep is Stuck in Four-Wheel Drive
Sometimes you may have engaged the 4WD because you were going off-road, but then you want to switch back to two-wheel drive when you get back on the pavement. You need to reset the system if the Jeep is stuck in a four-wheel drive.
How often should I reset the Jeep Grand Cherokee’s four-wheel drive system?
You only need to reset the system if there is a problem with the four-wheel drive. If everything is working properly, you don’t need to reset it.
How do I know if the four-wheel drive system is working properly?
You can test the four-wheel drive system by putting the Jeep in a four-wheel drive and driving around for a bit. If everything is working properly, you will hear the four-wheel drive engage and disengage as you turn.
Final Thoughts
Resetting the Jeep Grand Cherokee’s four-wheel drive system is a simple process that can be done at home. You can do this by following the steps outlined above. If you are not comfortable doing it on your own, visit a professional; mechanic to help you out. Remember, you should only reset the system if there is a problem with the four-wheel drive. Thanks for reading. I hope this article has helped you.
